Then recode with the manipulation profile the four parameters in the KOMBI again and that should do it.
Furthermore NCS Dummy can disassemble and assemble NCS Expert data files to. If you have any doubts just go back and default code the KOMBI, NFRM, JBBF, and CIC. NCS Dummy can be used to compare two trace files and show the differences. It sounds like you may have lucked into getting it right anyways if you have no errors and the tach is working correctly. My profile names are factory coding and manipulation, can't get them confused. Yes you would use manipulation for coding if trying to code different options to your car. Depending on where you downloaded from will have different names for the profiles. And 'Manipulation' is what I use for coding. Keep one that has manipulation checked and one that doesn't and since you found the profile editor open the profile info box and change the profile name of each to something that you know will differentiate between the two. So the 'Factory Coding' profile is 'expert mode'. Look to see if $2TC is gone and $2MK is there, they'll be at the front of your VO just a few characters in.Ĭheck your other profiles. Check your VO, it will show in NCS Expert after you pick CAS and hit back in your initial read. It's just easier to have the two different profiles rather than going back and forth changing one to fill both needs.
Well done! when ever you want to code/write to the cars modules use this one.Usually there's two or three profiles listed, what are the names of yours? Keep in mind the profile name can be changed to anything you want. Password is repxet).Ħ) Make sure under button ‘Individualisierung’ all options are crossed.ħ) Make sure under button ‘FSW/PSW’, that ‘from CVT’ is chosen, and that the bottom two boxes are crossed.Ĩ) Finally, press ‘consistence check’ and check it works. I’m going to show you how to setup a “coding” profile this is key to getting the actual programming correct, the profile will allow you to have the right permissions to code the modules.ġ) Open NCS Expert (usually icon on your desktop)ģ) Save as a new profile (Call it “coding” or something similar.
0 kommentar(er)
